Ford knock sensor

Last Updated on July 23, 2024 by Mutiara

To prevent the replacement of good components, be aware that the following non-EEC areas may be at fault:

  • Fuel (quality)
  • Fuel (octane)
  • Basic engine
  • Spark timing

The knock sensor is used to detect engine detonation (spark knock). As a result, a voltage sent to the PCM will retard spark timing. The KS is a piezoelectric accelerometer with the sensor designed to resonate at approximately the same frequency as the engine knock frequency. The KS uses the resonant frequency to mechanically amplify the vibrations. This method allows relatively large signals to be achieved without electrical amplification and with small package size.

The sensor has a thin circular piezoelectric ceramic disk which is bonded to a metal diaphragm. Electrical connections are made through a two pin integral connector.

VehicleKnock Resonace FrequencyPart Number
5.0L F-Series / Bronco / Econoline5.45KE3AF-AA
3.0L/3.2L Taurus SHO6.0KE5TF-AA
4.9L F-Series / Bronco / Econoline9.5KE9TF-AA
3.8L Supercharged Thunderbird5.7KE9SF-BA
4.6L 4V Mark VIII6.15KF3LF-AA
Related Posts
Ford EcoBoost engine
Ford EcoBoost engine

The 1.6 L 3 cylinder turbocharged EcoBoost engine is an upcoming design in a number of Ford vehicles wearing the Read more

Common Ford power steering issues
Common Ford power steering issues

Common Ford power steering issues Ford power steering pump with reservoir. The power steering system commonly found on most Ford Read more

Ford MTX-75 transmission
Ford MTX-75 transmission

The Ford MTX-75 (Manual TransaXle), is a 5-speed transmission developed by Ford Motor Company for its larger engined front wheel drive models. "75" refers to Read more

Ford Windstar modifications
Ford Windstar modifications

This page contains some modifications that were done to a Ford Windstar with a 3.8 Ford Essex engine for amusement. Read more

Article & images courtesy of fordfuelinjection.com

Similar Posts